Ali Editor for OpenBox S9 HD PVR

por Ospite Lun Ene 23, 2012 12:25 am

Ali Editor for OpenBox S9 HD PVR
This is the Ali Channel Editor for the OpenBox S9. If you have used the Ali Editor for Traxis you will find it functions similar. With this Ali implementation there are two portions to the file, Default Data and User Data. If you save the edited file as default data when you default the receiver all channels are erased and your sat/tp list becomes the default. To write your channel list, export a copy of the file as userdata. This file will add your channel list and your satellite list, which returns to the default one upon doing the factory reset.

Some further instruction:

Copying the file to USB
Plug in USB drive.

Go to MENU > TOOLS > DUMP BY USB

Arrow to MISC Files then arrow down to SELECT & DUMP and press OK

Press green button to add TP_PROG.dbs

Press yellow button to copy the file to your USB drive.

Loading/saving with Ali Editor

IMPORTANT: YOU MUST CHANGE THE .dbs EXTENSION TO .abs IN ORDER FOR THE ALi EDITOR TO PROCESS THE FILE. AFTER WORKING WITH THE FILE YOU MUST NAME IT BACK TO .dbs TO PROPERLY LOAD IT TO THE OPENBOX. FAILURE TO DO SO WILL RESULT IN FLASH FAILURE. USE AT YOUR OWN RISK!!!

In Ali Editor-

FILE > OPEN

A box appears. At the bottom select OPEN BIN FILE(*.abs). Then find the file you saved from the OpenBox.

When loading it will ask you if you want to work with default database or user database. Default database is just the satellite list & TP's from FridgeFTA/OpenBoxS9.us, no channels. User database contains the satellite list & TP's along with the channels, satellites and TP's that you have added. Select user database to work with your channels.

After working with the data do not save. Go to FILE > EXPORT. Select type as OPEN BIN FILE(*.abs) and save to your flash drive or other location. DON'T FORGET TO CHANGE THE EXTENSION TO .dbs BEFORE FLASHING BACK TO YOUR OPENBOX.

It will prompt you again if you want to export user database or default database. Select user database in most cases. Default Database will write your file perminately into memory, when you default the OpenBox all your data comes back. In many cases not a good idea.

Flashing the file to the OpenBox is the same as reading it from it, except select UPGRADE BY USB instead of DUMP BY USB.

After flashing your channel data, turn the OpenBox off for 10 seconds using the remote control. When you turn it back on your data file has replaced the data that was in memory. Failure to turn it off then on will result in a messed up channel list until you do so.

*** USE AT YOUR OWN RISK ***

Lun	Mar	Miér	Jue	Vie	Sáb	Dom
		1	2	3	4	5
6	7	8	9	10	11	12
13	14	15	16	17	18	19
20	21	22	23	24	25	26
27	28	29	30	31